Canon 1D Mark II
Review this page for information about the Canon 1D Mark II and its performance with PocketWizard radios.
- 1 General Canon Operational Considerations
- 2 1D Mark II Specific Operational Considerations
- 3 Canon Special Notes
General Canon Operational Considerations
The following operational considerations apply to all Canon cameras unless otherwise noted.
With a Canon camera and ControlTL radios the first exposure after initial connection or power-on is the calibration shot. It is recommended that you take the calibration shot at 1/125. This initiates communication between the camera and radio. This shot will not fire remote flashes.
Manually Select Camera Model
For best results with a Canon camera and ControlTL radios, be sure to manually select your camera model on the transmitting radio. Camera model selection is found on the "Channel" tab.
1D Mark II Specific Operational Considerations
The following operational considerations apply only to the 1D Mark II.
For best results, use the latest camera body firmware. The latest firmware for the 1D Mark II is Version 1.2.6, available for download at Canon U.S.A. Support & Drivers.
1D Mark II as Remote Camera
The 1D Mark II can be used as a remote camera with our Standard Channel radios or our ControlTL radios. ControlTL radios must be set to Basic Trigger mode. If the radios are set to ControlTL Channels, the 1D Mark II will not trigger.
Canon Special Notes
The following special notes apply to all Canon cameras.
In-Camera Speedlite Control
Speedlite controls set via the in-camera menus, like Flash Exposure Compensation and ratio settings, are not currently supported.
Rear-Curtain Sync and Bulb
Rear Curtain Sync and Bulb mode cannot be used together. For more information, visit our Rear Curtain Sync page.
Remote Infrared Control
ControlTL radios disable ALL infra-red/optical communication pulses used in Canon’s native TTL system, and will not trigger remote flashes configured to receive these pulses. A PocketWizard radio is required for each remote flash you want to trigger.
Unsupported Flash Modes
FEB (Flash Exposure Bracketing) and Stroboscopic Flash are not currently supported.
|Do you need personalized customer service?|
|If you need more information or personalized assistance, please contact us via our Inquiries Page.|