Search results

Create the page "$1" on this wiki! See also the search results found.

• PowerTracking
  ...ISO 200, and you adjusted ISO down to 100, your flash power level would be 1 stop brighter for all FEC settings. This operation assumes PowerTracking is ...eans 0 on your camera’s FEC equals 1/8 on your flash and FEC +3 equals 1/1 (full power). This setting may be customized using the PocketWizard Utility
  9 KB (1,476 words) - 11:35, 8 June 2017
• Remote Camera Triggering
  ...d Zone Triggering Channels. (Channels 17-32 with Legacy firmware, Channels 1-32 with E Release firmware) ...o be in the hot shoe to trigger the camera. Cables are available in either 1' or 3' lengths and we have a 10' extension cable (the MMX) so you can put t
  13 KB (2,323 words) - 14:08, 25 March 2024
• Learn Mode
  <div style="float: right;"><videoflash>vV0tLU03OAg&loop=1&rel=0&autoplay=0|225|155</videoflash></div> ...FlexTT5]] - turn the radio on and select the configuration to be taught, C.1 or C.2. Wait 3 or 4 seconds until you see the normal green blinks indicat
  12 KB (1,773 words) - 13:46, 8 July 2015
• Long Range Performance
  Maintain at least 36" (~ 1 meter) distance between antennas. Avoid direct antenna contact with anythin
  9 KB (1,401 words) - 07:52, 23 October 2018
• Nikon D800/D800E
  ...mm f/1.4D, Nikon AF Micro-Nikkor 60mm f/2.8D, and Nikon AF-S Nikkor 50mm f/1.8G.
  7 KB (953 words) - 08:59, 25 August 2021
• PowerST4
  ...C3 ZoneController]] and you can control three different zones of lights in 1/3-stop increments with up to a six-stop range. Utilize PocketWizard’s un '''1.''' Connect the PowerST4 to your RX flash pack via the remote port, then po
  13 KB (1,929 words) - 06:44, 9 July 2015
• Plus II
  ...s allow for top sync speeds of 1/250th-second for focal-plane shutters and 1/500th for leaf shutters. ...allowing for reliable sync speeds of 1/250th for focal plane shutters and 1/500th for leaf shutters.
  4 KB (553 words) - 10:03, 28 September 2022
• MiniTT1 and FlexTT5 Key Features
  ...High Speed Sync takes over for Speedlite flash photography all the way to 1/8000. ControlTL gains faster recycling times and more flashes per set of b
  4 KB (574 words) - 13:02, 30 August 2011
• Needs a home
  ...exposure, then those exposure settings will yield a flash output power of 1/8. Adjustments to aperture, ISO, and FEC will adjust flash output power acc ...ferent power outputs or to balance them. For example, you could set it to -1.0 to make an AlienBees B800 match the power of a B400.
  14 KB (2,325 words) - 14:36, 5 March 2014
• Plus III FAQ
  ...col than our Legacy firmware. Any Plus III radio purchased after September 1, 2019, from an authorized PocketWizard dealer may be eligible for the free ...ra in sync with remote flashes, be sure to set the flashes’ receivers to 1 Channel higher than the remote camera’s receiver. This is called [[Relay
  7 KB (1,147 words) - 16:25, 24 October 2021
• PowerMC2
  '''1.''' Check the [[#Transmitter Compatibility|Transmitter Compatibility]] sect ...NK from the transmitting Raven, in up to three different zones of light in 1/10 stop increments. Zone D is also available with manual power control. The
  19 KB (3,092 words) - 11:00, 12 November 2023
• AC9 AlienBees Adapter
  ...3 ZoneController]] and you can control three different groups of lights in 1/3-stop increments with a six-stop range. Utilize PocketWizard’s unique f #Shoot a calibration shot (1/125 for Nikon and 1/160 for Canon. The first shot for Canon will not fire the flash-shoot anoth
  9 KB (1,236 words) - 07:04, 15 October 2019
• Peanut2
  {| border="1"
  4 KB (524 words) - 08:35, 13 September 2011
• Channels (CE/Europe)
  === CE Standard Channels 1 through 16 === Standard Channels 1 through 16 are considered Classic or Legacy Channels and are the most basic
  7 KB (899 words) - 14:34, 7 August 2023
• Exposure Tab
  In the above example, setting -1 compensation for one of the flashes would cause that flash to always be one
  1 KB (187 words) - 13:31, 31 August 2011
• MiniTT1 and FlexTT5 Specifications
  {| border="1" class="wikitable" |Less than 0.001 watt (1/1000 of a watt or 1 milliwatt)
  3 KB (482 words) - 07:56, 9 January 2013
• AC7 RF Hard Shield
  {| style="float: right;" border="1" cellspacing="0" cellpadding="2"
  3 KB (419 words) - 08:26, 20 March 2014
• AC5 RF Soft Shield
  {| style="float: right;" border="1" cellspacing="0" cellpadding="2" ...le="float: left;"><videoflash>2laBHlESqAQ&loop=0&rel=0&autoplay=0&autohide=1</videoflash></div>
  4 KB (664 words) - 12:20, 24 May 2016
• AC3 ZoneController
  *6 stops of flash control in 1/3rd stop increments {| class="wikitable" border="1" align="center"
  8 KB (1,233 words) - 10:59, 30 August 2021
• The FAQ
  * Take your first shot at 1/160th or 1/200th so the system can properly calibrate timing. * The radio in your hand sends signal on Channel 1 (for example) to the radio attached to the camera. That radio triggers the
  11 KB (1,814 words) - 11:32, 2 February 2023