Compliance

From PocketWizard Wiki
Revision as of 06:37, 31 August 2011 by Ian (Talk | contribs)

Jump to: navigation, search

The FCC wants you to know:

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  1. Reorient or relocate the receiving antenna.
  2. Increase the separation between the equipment and the receiver.
  3. Consult the dealer or an experienced radio or television technician for help.

Canon MiniTT1 FCC ID Number: KDS-PW3-004 Canon FlexTT5 FCC ID Number: KDS-PW3-005 Nikon MiniTT1 FCC ID Number: KDS-PW3-007 Nikon FlexTT5 FCC ID Number: KDS-PW3-008


Industry Canada

This device complies with Part 15 of the FCC rules and also with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.


Canon MiniTT1 CANADA IC: 2170A-PW3004 Canon FlexTT5 CANADA IC: 2170A-PW3005 Nikon MiniTT1 CANADA IC: 2170A-PW3007 Nikon FlexTT5 CANADA IC: 2170A-PW3008